Cone Node¶

Generates a cone mesh that is optionally truncated.

Ingressi¶

Vertices: Number of vertices in the top and/or bottom circle of the cone. No geometry is generated if the number is below three.
Side Segments: Number of vertically stacked face loops that make up the cone’s sides. Increasing this will add horizontal cuts. No geometry is generated if the number is below one.
Fill Segments: Number of concentric rings in the top and/or bottom. No geometry is generated if the number is below one.
Radius Top: The radius of the cone’s top circle. If this is zero, the circle is reduced to a single vertex.
Radius Bottom: Same as Radius Top but for the bottom circle.
Depth: Height of the generated cone.

Nota

If the top and bottom radii are both zero, this node will output a single line.

Fill Type

How the circles at the top and bottom are filled with faces when their radius is larger than zero.

Nessuno:: Do not fill the circles.
N-Gon:: Fill the innermost circles with a single face.
Triangles:: Fill the innermost circles with triangles connected to a vertex in the center.

Mesh: Standard geometry output.
Sopra: A boolean field with a selection of the faces on the top of the cone. If the Fill Type is set to None, this will be a selection of the top edges instead. If Radius Top is zero, this will be a selection of the top vertex.
Side: A boolean field with a selection of the faces on the side of the cone.
Sotto: A boolean field with a selection of the faces on the bottom of the cone. If the Fill Type is set to None, this will be a selection of the bottom edges instead. If Radius Bottom is zero, this will be a selection of the bottom vertex.
UV Map: The default UV coordinate of each face corner. This can be connected to the Store Named Attribute Node for populating a UV Map.