Select All by Trait

Non-Manifold

Riferimento

Modalità:

Modalità Modifica

Menù:

Select ‣ Select All by Trait ‣ Non-Manifold

Selects the Non-manifold geometry of a mesh. This entry is available when editing a mesh, in Vertex and Edge selection modes only.

Estendi

Lets you extend the current selection.

Wire

Selects all the edges that do not belong to any face.

Boundaries

Selects edges in boundaries and holes.

Multiple Faces

Selects edges that belong to three or more faces.

Non Contiguous

Selects edges that belong to exactly two faces with opposite normals.

Vertices

Selects vertices that belong to wire and multiple face edges, isolated vertices, and vertices that belong to non-adjoining faces.

Loose Geometry

Riferimento

Modalità:

Modalità Modifica

Menù:

Select ‣ Select All by Trait ‣ Loose Geometry

This selection depends on the currently selected Selection Modes; In vertex and edge selection mode it selects all vertices or edges that do not form part of a face. In face selection mode it selects all faces that do not share edges with other faces.

Interior Faces

Riferimento

Modalità:

Modalità Modifica

Menù:

Select ‣ Select All by Trait ‣ Interior Faces

Selects faces where all edges have more than two faces.

Faces by Sides

Riferimento

Modalità:

Modalità Modifica

Menù:

Select ‣ Select All by Trait ‣ Faces by Sides

Selects all faces that have a specified number of edges.

Select By Pole Count

Riferimento

Modalità:

Modalità Modifica

Menù:

Select ‣ Select All by Trait ‣ Select by Pole Count

This operator selects all elements connected to Pole vertices, based on the number of edges connected to each pole.

  • In vertex selection mode, pole vertices are selected.

  • In edge selection mode, pole vertices and all their connected edges are selected.

  • In face selection mode, pole vertices and all their connected faces are selected.

../../../_images/modeling_meshes_editing_face_select_by_pole_count_before.webp

Before selecting poles.
../../../_images/modeling_meshes_editing_face_select_by_pole_count_after.webp

After selecting poles.
Pole Count

Specifies the number of edges a Pole must have to be included in the selection.

Tipo

Defines the comparison method for selecting poles:

Equal:

Includes poles with the specified number of edges.

Not Equal:

Includes poles with a number of edges different from the specified value.

Greater Than:

Includes poles with more edges than the specified value.

Less Than:

Includes poles with fewer edges than the specified value.

Estendi

Adds selected poles to the existing selection rather than replacing it.

Exclude Non-manifold

Skips poles that are part of Non-manifold geometry.

Suggerimento

Use this operator to inspect poles, which is particularly useful for identifying problematic poles during topology cleanup or for optimizing quad flow.

Ungrouped Vertices

Riferimento

Modalità:

Modalità Modifica

Menù:

Select ‣ Select All by Trait ‣ Ungrouped Vertices

Selects all vertices which are not part of a vertex group.