Solidify Faces

Riferimento

Modalità:

Modalità Modifica

Menù:

Face ‣ Solidify Faces

This takes a selection of faces and solidifies them by extruding them uniformly to give volume to a Non-manifold surface. This is also available as a Modifier. After using the tool, you can set the offset distance in the Regola Ultima Operazione panel.

Spessore

Amount to offset the newly created surface. Positive values offset the surface inward relative to the normals direction. Negative values offset outward.

Mesh before solidify operation.

Solidify with a positive thickness.

Solidify with a negative thickness.