Shrink/Fatten

Riferimento

Modalità:

Modalità Modifica

Strumento:

Toolbar ‣ Shrink/Fatten

Menù:

Mesh ‣ Transform ‣ Shrink/Fatten

Scorciatoia:

Alt-S

Moves the selected vertices «inwards» or «outwards» along their normal, all by the same distance.

After clicking the menu item or pressing the keyboard shortcut, move the mouse down to shrink or up to fatten. (Alternatively, type a distance on the keyboard.) Then press LMB or Return to confirm or RMB or Esc to cancel.

../../../../../_images/modeling_meshes_editing_mesh_transform_shrink-fatten_before.png

Mesh before shrink/fatten.
../../../../../_images/modeling_meshes_editing_mesh_transform_shrink-fatten_inflate-negative.png

Shrunk using a negative value.
../../../../../_images/modeling_meshes_editing_mesh_transform_shrink-fatten_inflate-positive.png

Fattened using a positive value.

Opzioni

These settings can be changed in the Regola Ultima Operazione panel.

Scostamento

How far to move each vertex.

Offset Even

When disabled, each vertex is offset by the same distance. When enabled, each edge is offset by the same distance.

This option can also be toggled before confirming by pressing S or holding Alt. (These shortcuts are shown in the status bar.)

../../../../../_images/modeling_meshes_editing_face_extrude-faces-normal_offset-even-off.png

Fattening with Offset Even disabled.
../../../../../_images/modeling_meshes_editing_face_extrude-faces-normal_offset-even-on.png

Fattening with Offset Even enabled.
Mirror Editing

Whether to also affect matching geometry on the other side of the mesh. Mesh Symmetry needs to be enabled for this to work.

Modifica Proporzionale

Vedi Modifica Proporzionale.