Installation on Linux#

このガイドでは次のトピックを紹介します：

Installing Dependencies#

Below are listed the installation commands for popular Linux distributions.

For the appropriate system, run the command in a terminal:

Debian/Ubuntu:

sudo apt-get install python3 python3-pip git git-lfs
git lfs install --skip-repo

Redhat/Fedora:

sudo dnf install python python-pip git git-lfs
git lfs install --skip-repo

Arch Linux:

sudo pacman -S python python-pip git git-lfs
git lfs install --skip-repo

Simply check out the Blender Manual's repository using:

cd ~
git clone https://projects.blender.org/blender/blender-manual.git

The repository will now be downloaded which may take a few minutes depending on your internet connection.

Tip

It is recommended to setup and activate a virtual Python environment where dependencies will be installed:

python3 -m venv .venv
source .venv/bin/activate

Repeat the source .venv/bin/activate command to re-activate the virtual environment, whenever you open a new terminal to build the documentation.

This step may be required on some distributions that enforce PEP 668.

Open a Terminal window.
Enter the blender-manual folder which was just added by git clone:
```
cd ~/blender-manual
```
Inside that folder is a file called requirements.txt which contains a list of all the dependencies we need. To install these dependencies, we can use the pip3 command:
```
pip3 install -r requirements.txt
```

注釈

時々ディペンデンシーを最新版にした方がいいでしょう。最新版にするには：

pip3 install -r requirements.txt --upgrade