Tips – Поради¶
As with all physics-enabled objects, pay close attention to the Animated checkbox in the Rigid Body panel of the Physics tab in the Properties. A common mistake is to use keyframe animation on a Passive physics object without checking the Animated box. The object will move, but the physics engine will behave as if the Passive is still in its starting place, leading to disappointment.
Animation – Анімація¶
The most common trick is to Keyframe animate the location or rotation of an Active physics object as well as the Animated checkbox. When the curve on the Animated property switches to disabled, the physics engine takes over using the object’s last known location, rotation and velocities.
Анімування сили різних інших параметрів (Скорість Цілі – Target Velocity для примуса «Двигун» – Motor, лімітів примусу «Шарнір» – Hinge тощо) може використовуватися для досягнення широкого спектру цікавих результатів.
Enabling a constraint during the physics simulation often has dramatic results as the physics engine tries to bring into alignment two objects which are often dramatically out of alignment. It is very common for the affected objects to build up enough kinetic energy to bounce themselves out of camera.
Rigid body dynamics can be baked to normal keyframes with Bake To Keyframes in the menu.
Стабільність Симуляції – Simulation Stability¶
The simplest way of improving simulation stability is to increase the steps per second. However, care has to be taken since making too many steps can cause problems and make the simulation even less stable (if you need more than 1000 steps, you should look at other ways to improve stability).
Збільшення кількості повторень рішальника допомагає зробити примушення сильнішими, а також підвищує стабільність стекування об’єктів.
It is best to avoid small objects, as they are currently unstable. Ideally, objects should be at least 20 cm in diameter. If it is still necessary, setting the collision margin to 0, while generally not recommended, can help making small object behave more naturally.
When objects are small and/or move very fast, they can pass through each other. Besides what is mentioned above it’s also good to avoid using mesh shapes in this case. Mesh shapes consist of individual triangles and therefore do not really have any thickness, so objects can pass through more easily. You can give them some thickness by increasing the collision margin.
Комбінування Твердих Тіл з Іншими Симуляціями – Combining Rigid Bodies with Other Simulations¶
Оскільки симуляція твердого тіла є частиною системи анімації, то вона може впливати на інші симуляції, як і сама система анімації на неї.
In order for this to work, the rigid body object needs to have a Collision Modifier. Simply click on Collision in the Physics tab.
Масштабування Твердих Тіл – Scaling Rigid Bodies¶
Rigid body objects can be scaled, also during the simulation. This work well in most cases, but can sometimes cause problems.
Якщо динамічне масштабування не потрібне, то для твердотілих об’єктів повинно бути застосовано масштаб за допомогою засобу «Застосувати Масштаб» – Apply Scale, Ctrl-A.