Пензлі – Brushes

Brush Types

See Brush Type.

Available brush types are listed here, together with brushes from the Essentials asset library using them.

Рисування – Draw

Brushes: Paint

Малює визначену вагомість по об’єкту.

Blend – Змішання

Режими змішання Blend Modes пензлів визначають спосіб, яким значення вагомості застосовується до групи вершин при малюванні.

Mix – Мішання

In this Blending mode the Weight value defines the target weight that will eventually be reached when you paint long enough on the same location of the mesh. And the strength determines how many strokes you need to place at the target weight. Note that for strength = 1.0 the target weight is painted immediately and for Weight = 0.0 the brush just does nothing.

Add – Додання

In this Blending mode the specified weight value is added to the vertex weights. The strength determines which fraction of the weight gets added per stroke. However, the brush will not paint weight values above 1.0.

Subtract – Відняття

In this Blending mode the specified weight value is subtracted from the vertex weights. The strength determines which fraction of the weight gets removed per stroke. However, the brush will not paint weight values below 0.0.

Lighten – Світління

In this Blending mode the specified weight value is interpreted as the target weight. Very similar to the Mix Blending mode, but only weights below the target weight are affected. Weights above the target weight remain unchanged.

Darken – Темніння

This Blending mode is very similar to the Lighten Blending mode. But only weights above the target weight are affected. Weights below the target weight remain unchanged.

Multiply – Множення

Multiplies the vertex weights with the specified weight value. This is somewhat like subtract, but the amount of removed weight is now dependent on the Weight value itself.

Blur – Розмив

Smooths out the weighting of adjacent vertices. In this mode the Weight Value is ignored. The strength defines how much the smoothing is applied.

Blur – Розмив

Brushes: Blur

Smooths out the weighting of adjacent vertices. In this mode the Weight Value is ignored. The strength defines how much the smoothing is applied.

Average – Усереднення

Brushes: Average

Згладжує вагомість шляхом малювання результатною вагомістю, усередненою з усіх вагомостей під пензлем.

Розмазання – Smear

Brushes: Smear

Smudges weights by grabbing the weights under the brush and «dragging» them. This can be imagined as a finger painting tool.