Draw

მითითება

რეჟიმი (Mode):

რედაქტირების რეჟიმი (Edit Mode)

ხელსაწყო (Tool):

Toolbar ‣ Draw

The Curve draw tool allows you to free-hand draw curves.

ხელსაწყოს ანაწყობები (Tool Settings)

Curve Stroke panel.

ტიპი (Type)

Type of curve to use for drawing.

Poly:

Bézier Curve with straight line segments (auto handles).

ბეზიე (Bézier):

Tolerance

Lower values give a result that is closer to the drawing stroke, while higher values give more smoothed results.

მეთოდი (Method)

Refit:

Incrementally refits the curve (gives best results).

გახლეჩა (Split):

Splits the curve until the tolerance is met (gives a better drawing performance).

Detect Corners

Detects corners while drawing based on a specified angle; Any angles above the specified value are considered corners. If a corner is detected, the curve uses non-aligned handles for the corner resulting in a more crisp corner.

Taper Start, End

Taper factor for the radius of the start and end points along the curve.

Radius Min

Minimum radius when the minimum pressure is applied (also the minimum when tapering).

Max

Radius to use when the maximum pressure is applied (or when a tablet is not used).

Use Pressure

Uses stylus pressure to control the radius of the curve.

სიღრმე (Depth)

Controls where and how the curves are drawn.

კურსორი (Cursor):

Uses the depth under the cursor to draw curves.

ზედაპირი (Surface):

Used to draw on top of other objects.

პროეცირება მონიშნულზე (Project Onto Selected)

მხოლოდ მონიშნულ ობიექტზე დააპროეცირე მონასმები.

აცდენა (Offset)

Distance to offset the curve from the surface.

Absolute Offset

Applies a fixed offset (does not scale by the curve radius).

Only First

Only uses the start of the stroke for the depth.

სიბრტყე (Plane)

The orientation plane to draw on, available when Only First is enabled.

Normal to Surface:

Draws aligned to the surface.

Tangent to Surface:

Draws perpendicular to the surface.

ხედი (View):

Draws aligned to the viewport.

ვარიანტები (Options)

After the tool is run, these options are available in the ბოლო ოპერაციის პარამეტრები (Adjust Last Operation) panel.

Error

Error distance in object units. This can be seen similar to a subdivision rate for the curve. Lower values give a result that is closer to the drawing stroke while higher values give more smoothed results.

Fit Method

Refit:

Incrementally refits the curve (gives best results).

გახლეჩა (Split):

Splits the curve until the tolerance is met (gives a better drawing performance).

კუთხის დახრილობა (Corner Angle)

Any angles above this are considered corners.

ციკლური (Cyclic)

Toggles whether or not the curve is Cyclic.