The Cylinder node generates a cylinder mesh. It is similar to the Cone node but always uses the same radius for the circles at the top and bottom.
Number of vertices on the circle at the top and bottom. No geometry is generated if the number is below three.
- Side Segments
Number of edges running vertically along the side of the cone. No geometry is generated if the number is below one.
- Fill Segments
Number of concentric rings used to fill the round faces at the top and bottom. No geometry is generated if the number is below one.
Distance of the vertices from the Z axis. If this is zero, the output will be a single line.
Height of the cylinder.
- Fill Type(フィルタイプ)
How the circles at the top and bottom are filled with faces when their radius is larger than zero.
Do not fill the circles.
Fill the innermost segment of the circles with a single face.
Fill the innermost segment of the circles with triangles connected to a new vertex on the Z axis.
A boolean attribute field with a selection of the faces on the top of the cylinder. If the Fill Type property is None, then this will be a selection of the top edges instead. If the Radius is zero, this will be a selection of the top point.
A boolean attribute field with a selection of the faces on the side of the cylinder.
This is the same as the Top selection output, but on the bottom side of the geometry instead.
- UV Map(UVマップ)
A 2D vector representing the default X/Y coordinates of the UV Map for the primitive's shape. This can be connected to the Store Named Attributeノード, to be used once the Geometry Nodes Modifier get applied. The UV map must be stored on the face corner in order to be accessed.