Select Linked

Linked

Reference

Mode

Edit Mode

Menu

Select ‣ Select Linked ‣ Linked

ショートカットキー

Ctrl-L

Select geometry connected to already selected elements. This is often useful when a mesh has disconnected, overlapping parts, where isolating it any other way would be tedious. To give more control, you can also enable delimiters in the Adjust Last Operation panel, so the selection is constrained by seams, sharp edges, materials or UV islands.

With Pick Linked you can also select connected geometry directly under the cursor, using the L shortcut to select or Shift-L to deselect linked. This works differently in that it uses the geometry under the cursor instead of the existing selection.

Shortest Path

Reference

Mode

Edit Mode

Menu

Select ‣ Select Linked ‣ Shortest Path

ショートカットキー

Ctrl-LMB

../../../_images/modeling_meshes_selecting_linked_shortest-path.png

Select a face or vertex path with Ctrl-LMB.

Selects all geometry along the shortest path from the active vertex, edge, or face to the one which was selected.

Edge Tag (in Edge select mode only)

This select button indicates what should be done when selecting a vertex path with Ctrl-LMB:

Select

Just selects all the edges in the path.

Tag Seam

Marks all edges in the path as seams for UV unwrapping.

Tag Sharp

Marks all edges in the path as sharp for the Edge Split Modifier.

Tag Crease

Marks all edges in the path as creases for the Subdivision Surface Modifier, with weight 1.0.

Tag Bevel

Gives bevel weight 1.0 (for the Bevel Modifier) to all edges in the path.

Tag Freestyle Edge Mark

Marks all edges in the path as Freestyle edges.

Face Stepping

頂点と面の対角線パスをサポートし、辺リングを選択します。

Topological Distance

距離の計算には、パスの辺の数のみが考慮され、辺の長さは考慮されません。

Fill Region Shift-Ctrl-LMB

アクティブな選択物から、クリックされた領域までの最短経路にあるすべての要素を選択します。

Checker Deselect Options

パス内の代替要素をすばやく選択できます。

Deselected

反復で選択解除された要素の数。

Selected

反復で選択された要素の数。

Offset

始点からのオフセット。

Linked Flat Faces

Reference

Mode

Edit Mode

Menu

Select ‣ Select Linked ‣ Linked

Selects all connected faces with a similar angle.

Sharpness (シャープ)

Todo.

../../../_images/modeling_meshes_selecting_linked_flat-faces.png

Looking at the image above, when at least one face is selected (as seen on the left), Linked Flat Faces will select all connecting faces that lie on the same or similar plane (as shown in the middle image). If the corners are smoothed, those faces are no longer lined up with the selected faces. At this point, increasing the Sharpness value in the tool options could include the smoothed faces.