Draw Face Sets

参照

Mode(モード):

Sculpt Mode(スカルプトモード)

Brush:

Sidebar ‣ Tool ‣ Brush Settings ‣ Advanced ‣ Brush Type

Draw new or extend existing Face Sets with each stroke.

Holding Ctrl will continue drawing the same face set as the one under the cursor. Holding Shift will relax or smooth the edges of the face sets by modifying the underlying topology so edges flow along the perimeter of the face sets. This will remove the jagged lines visible after drawing or creating a face set.

注釈

More information in the Face Set Introduction.

Brush Settings(ブラシ設定)

全般

While a lot of the general brush settings are supported, it's not needed to change them from the default, as the brush purpose is very simple.

注釈

More info at 全般 brush settings and on 高度な設定 brush settings.