Draw Face Sets

Reference

Mode:

Modo de escultura

Brush:

Sidebar ‣ Tool ‣ Brush Settings ‣ Advanced ‣ Brush Type

Draw new or extend existing Face Sets with each stroke.

Holding Ctrl will continue drawing the same face set as the one under the cursor. Holding Shift will relax or smooth the edges of the face sets by modifying the underlying topology so edges flow along the perimeter of the face sets. This will remove the jagged lines visible after drawing or creating a face set.

Nota

More information in the Face Set Introduction.

Brush Settings

Geral

While a lot of the general brush settings are supported, it’s not needed to change them from the default, as the brush purpose is very simple.

Nota

More info at Geral brush settings and on Avançado brush settings.