平面¶
参考
- 模式:
雕刻模式
- 笔刷:
Moves vertices toward the brush plane, along the plane normal. Generalizes the functionality of the 平化, 填充, and 刮削 brush types, allowing control of the range of influence above and below the brush plane through the Height and Depth parameters.
笔刷设置¶
通用¶
专用设置¶
- 高度
Determines the range of influence of the brush above the brush plane. Increasing the height affects vertices farther above the plane.
- 深度
Determines the range of influence of the brush below the brush plane. Increasing the depth affects vertices farther below the plane.
- 反转模式
Determines the behavior of the brush when inverted.
- 反转置换
When inverted, the brush displaces vertices away from the brush plane, resulting in increased contrast.
- 交换高度和深度
When inverted, the roles of the Height and Depth parameters are exchanged.
For example, if Height is set to 0.7 and Depth to 0.3, inverting the brush causes the roles of these parameters to be exchanged, resulting in an effective Height of 0.3 and Depth of 0.7.
- 稳定法向
Controls the stability of the brush plane's orientation. The normal of the plane is averaged over the last few stroke steps, with the number of steps and blending factor determined by the parameter's value.
When set to 0, the brush reacts immediately to changes in the in surface orientation.
When set to 1, the plane's orientation remains constant throughout the stroke.
Intermediate values provide a gradual transition between these behaviors, resulting in a weighted moving average of plane normals.
- 稳定平面
Controls the stability of the brush plane's position. Similar to Stabilize Normal, it works by averaging the position over the previous stroke steps.
Each position is calculated as the interpolated between the unstabilized position and its projection onto the plane of the previous stroke step.