Vẽ Mặt Ấn Định (Draw Face Sets)#
Tham Chiếu (Reference)
- Chế Độ (Mode):
Chế Độ Điêu Khắc (Sculpt Mode)
- Công Cụ (Tool):
Draw new or extend existing Face Sets with each stroke.
Holding Ctrl will continue drawing the same face set as the one under the cursor. Holding Shift will relax or smooth the edges of the face sets by modifying the underlying topology so edges flow along the perimeter of the face sets. This will remove the jagged lines visible after drawing or creating a face set.
Ghi chú
More information in the Face Set Introduction.
Các Cài Đặt của Đầu Bút#
Chung Chung (General)#
While a lot of the general brush settings are supported, it's not needed to change them from the default, as the brush purpose is very simple.
Ghi chú
More info at Chung Chung (General) brush settings and on Cao Cấp (Advanced) brush settings.