Generate Hair Curves
Generates new hair curves on a surface mesh. The curves are generated from scratch at point locations; if creating curves that depend on existing curves is desired, the Interpolate Hair Curves is a better choice.
This node/modifier will not function without the Surface geometry/object and Surface UV Map inputs.
Surface geometry for generation. This input takes priority over the corresponding object input if both are provided.
Surface object for generation (The transforms of this object must match the modifier object).
- Surface UV Map
Surface UV map stored on the mesh used for finding curve attachment locations.
- Surface Rest Position
Set the surface mesh into its rest position before attachment.
In a typical hair generation setup, this node or modifier will be combined with the Deform Curves on Surface Node. If that operation comes after this one, it makes sense to turn this option on so the position used is the pre-deformed position consistent with the expectations for the deformation's input.
- Hair Length
Length of the generated hair curves.
- Hair Material
Material of the generated hair curves.
- Control Points(制御点)
Amount of control points of the generated hair curves.
- Poisson Disk Distribution
Use poisson disk distribution method to keep a minimum distance. See the Distribute Points on Faces for more information.
Surface density of generated hair curves.
- Density Mask
Factor applied on the density for curve distribution.
- Mask Texture
Discard points based on an mask texture after distribution. The image is sampled with the Surface UV Map input.
The accuracy of sampling the image doesn't depend on the density of the surface mesh's vertices because it is sampled after the curve root points are generated, the accuracy . However, using the Density Mask input instead can give better performance. Using them in combination can give the benefits of both methods.
- Viewport Amount
Factor applied on the density for the viewport.
Random seed for the operation.
- Surface Normal
Normal direction of the surface mesh at the attachment point.