Направляющие (guides)#
Ссылка
- Режим (mode):
Draw Mode
- Колонтитул:
Guides are drawing aids that make it easier to create different types of strokes. The Guides can be activated with the button next to the selector (grid icon).
Guide Types#
Guide selector activated in the 3D Viewport header.#
- Circular:
Constrains the drawing of new strokes to form rings from the selected reference point.
- Радиально (radial):
Constrains the drawing of new strokes to form rays from the selected reference point.
- Parallel:
Constrains the drawing of new strokes to form parallel lines.
- Угол (angle)
Angle direction of the parallel lines.
- Сетка (grid):
Constrains the drawing of new strokes to form parallel horizontal or vertical lines.
- Isometric:
Constrains the drawing of new strokes to vertical or isometric lines.
- Угол (angle)
Angle direction of the isometric lines.
Общие параметры#
- Use Snapping
When enabled, snap the drawn strokes to an angle or spacing.
- Интервалы (spacing)
Расстояние между направляющими.
- Reference Point
Determines the origin point to use for the creation of the lines. Applies only for Circular and Radial guides.
- Курсор (сursor):
Use the cursor as a reference point.
- Особый (custom):
Use a custom location as a reference point.
- Custom Location
X, Y Z
- Объект (object):
Use an object as a reference point.
- Объект (object)
A Data ID menu to select the object (usually an empty), which location will be used as a reference point.
