Những Công Cụ Cử Chỉ (Gesture Tools)¶
Separate from brushes and filters, Sculpt mode also has a set of tools that perform actions to a drawn selection area. These tools are similar to the selection tools (e.g. box selection and lasso selection in other areas of Blender).
These tools do not provide a selection of elements that are then modified, they directly modify the underlying mesh.
Cử Chỉ [Box Gestures]¶
Dragging creates a rectangular area defined by where LMB was pressed and where LMB is released.
Các Điều Khiển (Controls)¶
- Di Chuyển (Move) Dấu Cách (Spacebar)
Giữ tới reposition the lựa chọn khu vực/diện tích.
Cử Chỉ [Lasso Gestures]¶
Dragging creates a freeform area that follows the cursor defined by where LMB was pressed and where LMB is released.
Các Điều Khiển (Controls)¶
- Di Chuyển (Move) Dấu Cách (Spacebar)
Giữ tới reposition the lựa chọn khu vực/diện tích.
Các Cài Đặt của Công Cụ (Tool Settings)¶
- Ổn Định Hóa Nét Vẽ (Stabilize Stroke)
Giúp thuyên giảm độ rung của các nét trong khi vẽ bằng cách trì hoãn và sửa vị trí của các điểm.
- Bán Kính (Radius)
Khoảng cách tối thiểu từ điểm cuối cùng trước khi nét vẽ tiếp tục.
- Hệ Số (Factor)
Một hệ số làm mịn, where higher giá trị kết quả vào/trong mịn màng hơn nét vẽ but the vẽ sensation feels as nếu you were pulling the nét vẽ.
Cử Chỉ [Line Gestures]¶
Dragging creates a line. The resulting action acts upon everything on the highlighted side of the line. The area acted upon is extended in both directions of the viewport.
Các Điều Khiển (Controls)¶
- Đảo Lật (Flip) F
Bật/Tắt the bên của đường nét/thẳng that the công cụ ảnh hưởng.
- Bám Dính (Snap) Ctrl
Hold to constrain the rotation of the line to user-specified intervals. Defaults to 5 degree increments, customizable via the Snapping menu indicated by the magnet icon in the header.
- Di Chuyển (Move) Dấu Cách (Spacebar)
Giữ tới reposition the đường nét/thẳng.
Các Cài Đặt của Công Cụ (Tool Settings)¶
- Giới Hạn trong Phân đoạn (Limit to Segment)
The affected area will not extend the length of the drawn line. This helps defining a smaller area instead of extending the line infinitely long.
Đường Đa Giác [Polyline Gestures]¶
Clicking places a point in the viewport. Each time LMB is pressed, a new point of the polygon is created. Pressing LMB on the starting point, pressing LMB twice, or pressing Return closes the selection area.
Các Điều Khiển (Controls)¶
- Di Chuyển (Move) Dấu Cách (Spacebar)
Giữ tới reposition the lựa chọn khu vực/diện tích.