Xé Điểm Đỉnh (Rip Vertices)

Tham Chiếu [Reference]

Chế Độ [Mode]:

Chế Độ Biên Soạn [Edit Mode]

Trình Đơn [Menu]:

Điểm Đỉnh (Vertex) ‣ Xé Điểm Đỉnh (Rip Vertices)

Tổ Hợp Phím Tắt [Shortcut]:

V

Cuts the mesh open along two neighboring edges of each selected vertex. The vertices can then be moved away using the mouse to create a hole. When they're in the desired position, press LMB or Return to confirm. Alternatively, press RMB or Esc to leave them at their original position (but still disconnected).

When a single vertex is selected, the cutting direction is determined by the position of the mouse cursor. Otherwise, it's determined by the orientation of the selected edge(s).

Ghi chú

Rip Vertices doesn't support "ripping out" entire faces from their surroundings. Use Split Selection instead.

Xem thêm

Split Faces by Edges only cuts along the selected edges, leaving surrounding unselected edges unchanged.

Một Số Ví Dụ (Examples)

Ripping a single vertex:

Mouse cursor to the right.	Ripping results in a vertical cut.
Mouse cursor below.	Ripping results in a horizontal cut.

Ripping vertices along edges in one direction:

Vertical edges selected.

Ripping cuts vertically regardless of mouse position.

As a less common scenario, it's also possible to cut in multiple directions:

Before ripping.

After ripping.

Ripping multiple disjoint "islands" of vertices, however, is not supported and will result in an error.