Giao Cắt [Dao] (Intersect [Knife])¶
Tham Chiếu [Reference]
- Chế Độ [Mode]:
Chế Độ Biên Soạn [Edit Mode]
- Trình Đơn [Menu]:
Creates new edges along the lines where faces intersect.
Xem thêm
Giao Cắt [Bool] (Intersect [Boolean]) in Union mode doesn't just create intersection edges, but also removes faces that end up enclosed in a volume.
Các Tùy Chọn (Options)¶
- Nguồn (Source)
- Tự Giao Cắt (Self Intersect)
Intersect selected faces with other selected faces.
- Chọn/Chưa Chọn (Selected/Unselected)
Intersect selected faces with unselected faces.
- Chế Độ Tách Phân (Separate Mode)
Whether to disconnect faces from each other after edge creation.
- Toàn Bộ (All):
Disconnect all faces at each intersection edge.
- Cắt (Cut):
If Source is set to Selected/Unselected, only disconnect the selected faces from the unselected ones. Otherwise, this option does the same as All.
- Hợp Nhất [Merge]:
Connect all faces at each intersection edge.
Separate All: the cylinder and the plane stay separate and are each split in two.¶ |
Separate Cut: the cylinder and the plane stay separate.¶ |
Merge: the cylinder and the plane are connected to each other.¶ |
- Trình Giải Nghiệm (Solver)
Thuật toán sử dụng để tính toán các vùng giao cắt.
- Số Thực (Float)
Uses a simple solver which offers good performance but lacks support for overlapping geometry.
- Giới Hạn Hợp Nhất (Merge Threshold)
Dung sai cho các mặt nằm gần được coi là chạm nhau. Tăng giá trị này lên khi một số sự giao cắt không được phát hiện có thể là một việc nên làm, và khi hình học bổ sung được kiến tạo do các cạnh không được phát hiện là chồng chéo lên nhau.
Cảnh báo
A threshold approaching the size of faces may cause very slow calculation. In general, keep this value small.
- Chính Xác (Exact)
Uses a complex solver which offers the best results and has full support for overlapping geometry, but is much slower.