Nút Đặt Pháp Tuyến Đường Cong (Set Curve Normal Node)

Nút Đặt Pháp Tuyến Đường Cong.

The Set Curve Normal controls the method used to calculate curve normals for every curve.

The node doesn't set the normals directly, those are calculated later as necessary. Combined with the tilt attribute value at each control point, this will define the final normals accessible with the Nút Pháp Tuyến (Normal Node).

Internally this node adjusts the values of the normal_mode attribute on each curve.

Đầu Vào (Inputs)

Curve (Đường Cong)

Đầu vào hình học tiêu chuẩn, có chứa các đường cong.

Lựa Chọn (Selection)

Có thay đổi giá trị trên mỗi đường cong hay không.

Chế Độ [Mode]

Phương pháp tính toán các pháp tuyến của đường cong

Độ Xoắn Tối Thiểu [Minimum Twist]:

Các pháp tuyến sau cùng được tính toán để có độ xoắn nhỏ nhất xung quanh tiếp tuyến của đường cong trên toàn bộ đường cong.

Z-Hướng lên (Z-Up):

The kết thúc pháp tuyến sẽ được tính toán so that they sẽ được perpendicular tới the Z Trục và the Tiếp Tuyến. nếu một series của Điểm được Chiều Dọc, the X trục được used.

Tự Do (Free):

Use the stored custom normal attribute (custom_normal) as the final normals.

This mode adds a Normal input that can be used to set the value of the custom normal.

Ghi chú

Custom normals are not rotation invariant, meaning normals must be set after any rotation transformations; i.e. at the end of the node tree or at the bottom of the modifier stack.

Normal Free

Input for the custom normal attribute (custom_normal) when using Free mode.

Đầu Ra (Outputs)

Curve (Đường Cong)

Đầu ra hình học tiêu chuẩn.