Разделить (split)

The Split menu can be accessed as a popover by pressing Alt-M.

These operators are about splitting meshes by disconnecting faces from each other. For splitting faces into smaller ones, see the Инструмент топологической резки (knife topology tool) or the Соединить вершины по линии (connect vertex path) operator.

Split Selection

Ссылка

Режим (mode):

Режим редактирования (edit mode)

Меню:

Меш ‣ Разделить ‣ Выделение Mesh ‣ Split ‣ Selection

Горячая клавиша:

Y

Cuts the mesh along the border of the selected faces. The faces can then be moved elsewhere.

This operator can also disconnect «wires» (edges that are not part of a face) from their surroundings. However, using it on edges that are part of a face will simply duplicate them.

Disconnecting inner faces from their surroundings.

См. также

The Отделить (separate) operator disconnects the selection and moves it into a new mesh object.

Split Faces by Edges

Ссылка

Режим (mode):

Режим редактирования (edit mode)

Меню:

Меш ‣ Разделить ‣ Грани по рёбрам Mesh ‣ Split ‣ Faces by Edges

Cuts the mesh along the selected edges. The vertices can then be pulled apart to create a hole.

Splitting by selected edges.

См. также

Разорвать вершины (rip vertices) also cuts neighboring unselected edges.

Split Faces & Edges by Vertices

Ссылка

Режим (mode):

Режим редактирования (edit mode)

Меню:

Меш ‣ Разделить ‣ Грани и рёбра по вершинам Mesh ‣ Split ‣ Faces & Edges by Vertices

Cuts the mesh along all neighboring edges of each selected vertex. (This is different from Rip Vertices which only cuts two edges per vertex.)

The vertices can then be pulled apart to create a hole.

Splitting by selected vertices.