Cast Modifier

The Cast modifier shifts the shape of a mesh, curve, surface or lattice, towards any of a few predefined shapes (sphere, cylinder, cuboid).

It is equivalent to the To Sphere tool in Edit Mode, and what other programs call «Spherify» or «Spherize», but, as written above, it is not limited to casting to a sphere.

Совет

The Smooth Modifier is a good companion to Cast, since the cast shape sometimes needs smoothing to look nicer or even to fix shading artifacts.

Примечание

For performance reasons, this modifier only works with local coordinates. If the modified object looks wrong, you may need to apply its transformations, especially when casting to a cylinder.

Опции (options)

The Cast modifier.

Форма (shape)

Menu to choose target shape of the projection: Sphere, Cylinder or Cuboid.

Ось (axis)

Toggle buttons to enable/disable the modifier in the X, Y, Z axes directions (X and Y only for Cylinder cast type, since the Z axis remains unaffected).

Коэффициент (factor)

The factor to control blending between original and cast vertex positions.

It is a linear interpolation: 0.0 gives original coordinates (i.e. modifier has no effect), 1.0 casts to the target shape.

Values below 0.0 or above 1.0 exaggerate the deformation, sometimes in interesting ways.

Радиус (radius)

If nonzero, this radius defines a sphere of influence. Vertices outside it are not affected by the modifier.

Размер (size)

Alternative size for the projected shape. If zero, it is defined by the initial shape and the control object, if any.

Size from Radius

If activated, calculate Size from Radius, for smoother results.

Группа вершин (vertex group)

If set, restrict the effect to the only vertices in that vertex group. This allows selective, real-time casting, by painting vertex weights.

Переставить <->

Инвертирует влияние выбранной группы вершин, что означает, что теперь группа представляет вершины, которые не будут деформированы модификатором.

Эта настройка меняет значения веса группы на противоположные.

Объект (object)

The name of an object to control the effect. The location of this object’s origin defines the center of the projection. Also, its size and rotation transform the projected vertices.

Подсказка

Animating (keyframing) this control object also animates the modified object’s casting deformation.

Пример

Top: Suzanne without modifiers. Middle: Suzanne with each type of Cast Modifier (Sphere, Cylinder and Cuboid). Bottom: Same as above, but now only X axis is enabled. Sample blend-file.