Line Project

Ссылка

Режим (mode):

Режим скульптинга (sculpt mode)

Инструмент (tool):

Toolbar ‣ Line Project

This tool flattens the geometry along a plane determined by the camera view and a drawn line. The region of the mesh being flattened is visualized by the side of the line that is shaded.

../../../_images/sculpt-paint_sculpting_tools_line-project_before.png

Before Line Project.
../../../_images/sculpt-paint_sculpting_tools_line-project_after.png

After Line Project.

Использование

Use the tool by:

  1. Orient the 3D Viewport to define the direction in depth.

  2. LMB and hold while moving the cursor to define direction of the line projection.

  3. Adjust the operation with extra Controls shortcuts.

  4. Release LMB to confirm.

Элементы управления

Развернуть (flip) F

Changes the side of the line that the tool projects geometry.

Привязать (snap) Ctrl

Ограничивает вращение линии разреза интервалом в 15 градусов.

Move Ctrl-Spacebar

Изменить положение линии.

Настройки панели «Инструмент» (tool settings)

Limit to Segment

The affected area will not extend the length of the drawn line. This helps defining a smaller area instead of extending the line infinitely long