绘制面组

参考

模式:

雕刻模式

笔刷:

资产架 ‣ 绘制面组

Draw new or extend existing Face Sets with each stroke.

Holding Ctrl will continue drawing the same face set as the one under the cursor. Holding Shift will relax or smooth the edges of the face sets by modifying the underlying topology so edges flow along the perimeter of the face sets. This will remove the jagged lines visible after drawing or creating a face set.

Note

更多信息见于 面组介绍

笔刷设置

通用

While a lot of the general brush settings are supported, it's not needed to change them from the default, as the brush purpose is very simple.

Note

More info at 通用 brush settings and on 高级 brush settings.