手势工具

Separate from brushes and filters, Sculpt mode also has a set of tools that perform actions to a drawn selection area. These tools are similar to the selection tools (e.g. box selection and lasso selection in other areas of Blender).

These tools do not provide a selection of elements that are then modified, they directly modify the underlying mesh.

框选手势

Dragging creates a rectangular area defined by where LMB was pressed and where LMB is released.

控制器

移动 空格键

Hold to reposition the selection area.

套索手势

Dragging creates a freeform area that follows the cursor defined by where LMB was pressed and where LMB is released.

控制器

移动 空格键

Hold to reposition the selection area.

工具设置

笔画防抖

通过延迟和校正点的位置来帮助减少绘画时的笔锋抖动。

半径

笔锋继续前,到最后一点的最小距离。

系数

A smooth factor, where higher values result in smoother strokes but the drawing sensation feels as if you were pulling the stroke.

划线手势

Dragging creates a line. The resulting action acts upon everything on the highlighed side of the line. The area acted upon is extended in both directions of the viewport.

控制器

翻转 F

Toggles the side of the line that the tool affects.

吸附 Ctrl

Hold to constrain the rotation of the line to user-specified intervals. Defaults to 5 degree increments, customizable via the Snapping menu indicated by the magnet icon in the header.

移动 空格键

Hold to reposition the line.

工具设置

限制到线段

The affected area will not extend the length of the drawn line. This helps defining a smaller area instead of extending the line infinitely long.

折线手势

Clicking places a point in the viewport. Each time LMB is pressed, a new point of the polygon is created. Pressing LMB on the starting point or pressing Return closes the selection area.

控制器

移动 空格键

Hold to reposition the selection area.