Nodo Normal

The Normal node returns a vector for each evaluated point indicating the normal direction. The output can depend on the attribute domain used in the node evaluating the field, but the output is always a normalized unit vector.

Cara:

On the face domain, the normal is the «up» direction of the face.

Mesh Vertices:

For mesh vertices, the normal is an average of the surrounding face normals. If the vertex does not have any connected faces, the output is simply the normalized position of that vertex.

Borde:

The normal output for each edge is the average of the edge’s two vertex normals.

Esquina de cara:

The output for each face corner is the same as the face normal of the corresponding face.

Curve Control Points:

The output of this node when used for curve geometry is the evaluated normal of the curve, which depends on the twist method. The normal vector is always perpendicular to the direction of the curve’s path at every point.

Advertencia

For NURBS and Bézier spline curves, keep in mind that the value retrieved from this node is the value at every control point, which may not correspond to the visible evaluated points. For NURBS splines the difference may be even more pronounced and the result may not be as expected. A Nodo Remuestrear curva can be used to create a poly spline, where there is a control point for every evaluated point.

Entradas

Este nodo no contiene entradas.

Propiedades

Este nodo no contiene propiedades.

Salidas

Normal

Vector indicating the normal of each geometry element.