Seleccionar por condición

Non Manifold

Referencia

Modo:

Modo Edición

Menú:

Select ‣ Select All by Trait ‣ Non Manifold

Selects the non-manifold geometry of a mesh. This entry is only available in the Vertex and Edge selection modes.

Opciones

Extender

Adds to the current selection instead of replacing it.

Estructura

Selects edges that do not belong to any face.

Límites

Selects edges at boundaries and holes.

Múltiples caras

Seleccionará bordes que pertenezcan a tres o más caras.

No contiguos

Seleccionará bordes que pertenezcan exactamente a dos caras con normales opuestas.

Vértices

Selects vertices that are isolated, belong to an edge that’s a Wire or has Multiple Faces, or are the only vertex connecting two faces.

Geometría suelta

Referencia

Modo:

Modo Edición

Menú:

Seleccionar ‣ Seleccionar por condición ‣ Geometría suelta

Depending on the selection mode, this operator selects vertices that are not part of any edge, edges that are not part of any face, or faces that do not share an edge with any other face.

Caras interiores

Referencia

Modo:

Modo Edición

Menú:

Seleccionar ‣ Seleccionar por condición ‣ Caras interiores

Selects faces that may have been accidentally created inside the mesh instead of on the mesh’s surface. Specifically, it selects faces with «abnormal» neighbors (multiple neighbors connected to the same edge), as well as any «normal» neighbors of those faces.

Caras por lados

Referencia

Modo:

Modo Edición

Menú:

Seleccionar ‣ Seleccionar por condición ‣ Caras por lados

Selects all faces that have a certain number of edges. The number can be specified in the Ajustar última operación panel.

Poles by Count

Referencia

Modo:

Modo Edición

Menú:

Select ‣ Select All by Trait ‣ Poles by Count

Finds vertices that are a pole, namely vertices that are connected to an irregular number of edges. Then, selects either those poles (in vertex selection mode) or the edges/faces connected to them (in edge/face selection mode).

Antes de seleccionar los polos.

Después de seleccionar los polos.

Opciones

Cantidad en polos

Specifies the number of edges a vertex must (not) have to be considered a pole.

Tipo

Defines the comparison method for determining poles:

Menor que:

Find vertices that have fewer edges than Pole Count.

Igual a:

Find vertices that have exactly Pole Count edges.

Mayor que:

Find vertices that have more edges than Pole Count.

Not Equal To:

Find vertices that have more or fewer edges than Pole Count.

Extender

Adds to the existing selection rather than replacing it.

Exclude Non Manifold

Skips poles that are part of non-manifold geometry.

Consejo

Poles can cause ugly pinching when using the Modificador Subdividir superficie, so this operator is useful for finding them.

Vértices no agrupados

Referencia

Modo:

Modo Edición

Menú:

Seleccionar ‣ Seleccionar por condición ‣ Vértices no agrupados

Selects all vertices that are not part of any vertex group.