Curve Handle Positions Node¶
Gets the two handle positions of each control point in a Bézier spline.
You can use the Нода «Установить положения ручек» (set handle positions node) to change these positions.
Входы (inputs)¶
- Относительно (relative)
Output the handle positions relative to the control point instead of in the local space of the geometry.
Свойства¶
Эта нода не содержит свойств.
Выходы (outputs)¶
- Слева (left)
The position of the control point’s left handle.
- Справа (right)
The position of the control point’s right handle.