Mesh Analysis (проверка сетки)

Справка

Mode:

Режим редактирования

Panel:

Header ‣ Overlays ‣ Mesh Analysis

Анализ меша полезен для отображения атрибутов меша, которые могут повлиять на определённые сценарии использования.

Анализ сетки работает в режиме редактирования и сплошного затенения . Он показывает области с высоким значением красным цветом, а области с низким значением - синим. Геометрия за пределами диапазона отображается серым цветом.

В настоящее время различные режимы нацелены на 3D-печать в качестве основного использования.

Overhang

Экструзионные 3D-принтеры имеют физическое ограничение на печать нависаний. Этот режим отображения показывает нависания с диапазоном углов и выбором оси.

Minimum/Maximum

Minimum/Maximum angle to display.

Axis (Ось)

Axis and direction to use as the bases to calculate the angle to visualize.

../../_images/modeling_meshes_mesh-analysis_overhang.png

Overhang.

Толщина

Printers have a limited wall-thickness where very thin areas cannot be printed, this test uses ray casting and a distance range to the thickness of the geometry.

Minimum/Maximum

Minimum/Maximum thickness to display.

Сэмплы

Number of samples to use to calculate the thickness.

../../_images/modeling_meshes_mesh-analysis_thickness.png

Thickness.

Intersections

Another common cause of problems for printing are intersections between surfaces, where the inside/outside of a model cannot be reliably detected.

Unlike other display modes, intersections have no variance and are either on or off.

../../_images/modeling_meshes_mesh-analysis_intersections.png

Intersecting faces.

Distortion (искажение)

Distorted geometry can cause problems since the triangulation of a distorted n-gon is undefined.

Distortion is measured by faces which are not flat, with parts of the face pointing in different directions.

Minimum/Maximum

Minimum/Maximum distortion to display.

../../_images/modeling_meshes_mesh-analysis_distortion.png

Distorted Faces.

Sharp Edges

Similar to wall-thickness, sharp edges can form shapes that are too thin to be able to print.

Minimum/Maximum

Minimum/Maximum angle to display.

../../_images/modeling_meshes_mesh-analysis_sharp-edges.png

Sharp edges.

Известные ограничения

There are some known limitations with mesh analysis:

  • Currently only displayed with Deform Modifiers.

  • For high-poly meshes the performance is low while editing.