Generate Hair Curves#

Generates new hair curves on a surface mesh. The curves are generated from scratch at point locations; if creating curves that depend on existing curves is desired, the Interpolate Hair Curves is a better choice.

Примечание

This node/modifier will not function without the Surface geometry/object and Surface UV Map inputs.

Входы#

Surface (поверхность)

Surface geometry for generation. This input takes priority over the corresponding object input if both are provided.

Surface (поверхность)

Surface object for generation (The transforms of this object must match the modifier object).

Surface UV Map

Surface UV map stored on the mesh used for finding curve attachment locations.

Surface Rest Position

Set the surface mesh into its rest position before attachment.

Совет

In a typical hair generation setup, this node or modifier will be combined with the Deform Curves on Surface Node. If that operation comes after this one, it makes sense to turn this option on so the position used is the pre-deformed position consistent with the expectations for the deformation’s input.

Hair Length

Length of the generated hair curves.

Hair Material

Material of the generated hair curves.

Контрольные точки

Amount of control points of the generated hair curves.

Poisson Disk Distribution

Use poisson disk distribution method to keep a minimum distance. See the Узел Distribute Points on Faces for more information.

Density (плотность)

Surface density of generated hair curves.

Density Mask

Factor applied on the density for curve distribution.

Mask Texture

Discard points based on an mask texture after distribution. The image is sampled with the Surface UV Map input.

Совет

The accuracy of sampling the image doesn’t depend on the density of the surface mesh’s vertices because it is sampled after the curve root points are generated, the accuracy . However, using the Density Mask input instead can give better performance. Using them in combination can give the benefits of both methods.

Viewport Amount

Factor applied on the density for the viewport.

Seed (вариация)

Random seed for the operation.

Свойства#

Этот узел не содержит свойств.

Выходы#

Geometry

Curves

Surface Normal

Normal direction of the surface mesh at the attachment point.