Cache#
The Cache is used to save preview frames in memory, so they can later be displayed much faster than if they were rendered from scratch. Cache capacity can be set in the System tab of the Preferences.
In order for this tab to be visible, enable Developer Extras.
См.также
Which frames are cached can be visualized by enabling Show Cache.
Cache Settings#
Справка
- Panel:
In this panel, you can select the preview rendering stages at which strip images should be cached. These settings apply to all strips.
- Cache
- Raw
Cache raw images right after they’re read from the drive, for faster tweaking of strip parameters at the cost of memory usage.
- Pre-processed
Cache strip images after applying cropping, scaling, saturation and so on, for faster tweaking of effects at the cost of memory usage.
- Composite
Cache strip images after blending with lower channels and applying effects, for faster tweaking of stacked strips at the cost of memory usage.
- Final
Cache the final rendered frame.
Strip Cache#
Справка
- Panel:
This panel sets the types of images that will be cached for the active strip. When enabled, these properties override the above Cache Settings.
- Cache
- Raw
Cache raw images read from drive, for faster tweaking of strip parameters at the cost of memory usage.
- Preprocessed
Cache preprocessed images, for faster tweaking of effects at the cost of memory usage.
- Composite
Cache intermediate composited images, for faster tweaking of stacked strips at the cost of memory usage.