Multiplane Scrape

Référence

Mode

Mode Sculpture

Outil

Toolbar ‣ Multiplane Scrape

Scrapes the mesh with two angled planes at the same time, creating a sharp edge between them. This is useful for creating & polishing hard surface objects.

Paramètres des brosses

Général

Note

More info at Général brush settings and on Avancé brush settings.

Unique

Plane Angle

L’angle entre les deux plans de la brosse, en appuyant sur Ctrl inverse l’angle.

Dynamic Mode

When enabled, the angle is dynamically updated based on the surface under the brush. The Plane Angle then controls how much the angle will increase when applying pen pressure. When pressing Ctrl, it locks the plane angle to 0 degrees.

Show Cursor Preview

Displays a preview of the two planes and the angle they form during the stroke.