Boundary – Рубіж
Reference – Довідка
- Mode – Режим:
Sculpt Mode – Режим Ліплення
- Tool – Засіб:
Similar to the Pose brush but deforms the open boundaries of a mesh. The tool detects the mesh boundary closest to the active vertex and propagates the deformation using the brush Falloff into the mesh.
The main use cases of this brush are the Bend and Expand geometry, which leads to the best results on evenly distributed quad based topology. Use the Inflate, Grab, Twist, and Smooth deformation modes, to further adjustments and tweaks to the result (which do not depend that much on a clean topology).
Boundaries to hidden geometry will also be counted as an open boundary.
The boundary origin is displayed via a white line, which indicates the reach of the deformation. The targeted boundary that will be deformed is highlighted in the brush cursor color.
If the Deformation Target is changed, the brush can also be used for cloth sculpting.
Evenly distributed and quad based topology will lead to much better results. Triangles and N-gons are also supported but may lead to unpredictable outcomes.
Устави Пензля – Brush Settings
General – Загальне
More info at General – Загальне brush settings and on Advanced – Просунуто brush settings.
- Деформація – Deformation
Deformation type that is used by the brush.
- Згин – Bend
Rotates the boundary around the local Y axis. Useful for creating folding shapes, like sleeves.
Moves/extends the mesh boundary in the local X direction. Useful for extending the boundaries along the surface.
- Надуття – Inflate
Works similar to the Inflate tool but, the vertices that are inflated are constrained to the mesh boundary.
- Grab – Захоп
Works similar to the Grab tool but, the vertices that are grabbed are constrained to the mesh boundary.
- Twist – Кручення
Rotates the active boundary around the local Z axis. Useful for creating folds like on a skirt.
- Smooth – Згладження
Works similar to the Grab tool but, the vertices that are smoothed are constrained to the mesh boundary.
- Boundary Falloff
How the brush Falloff is applied across the boundary.
- Constant – Константно
Applies the same deformation in the entire boundary.
- Brush Radius
Applies the deformation only within the brush radius.
- Loop – Зациклення
Applies the brush falloff in a loop pattern along the boundary.
- Loop and Invert
Applies the falloff radius in a loop pattern, inverting the direction back & forth.
- Boundary Origin Offset
Offset of the boundary origin in relation to the brush radius.