Draw Face Sets

Reference – Довідка

Mode – Режим:

Sculpt Mode – Режим Ліплення

Tool – Засіб:

Toolbar ‣ Draw Face Sets

Draw new or extend existing Face Sets with each stroke.

Holding Ctrl will continue drawing the same face set as the one under the cursor. Holding Shift will relax or smooth the edges of the face sets by modifying the underlying topology so edges flow along the perimeter of the face sets. This will remove the jagged lines visible after drawing or creating a face set.


More information in the Face Set Introduction.

Устави Пензля – Brush Settings

General – Загальне

While a lot of the general brush settings are supported, it’s not needed to change them from the default, as the brush purpose is very simple.


More info at General – Загальне brush settings and on Advanced – Просунуто brush settings.